🔌 Enhance Your Automotive Electrical System with Standard Motor Products S635 Pigtail/Socket Review

The fit is very snug so it took me a little effort to get it on the temp sensor at first but it fits. I had to remove the old connector and solder this one on. A working temperature sensor is now fitted with a new coolant temperature sensor and connector. Mounted on a 95 foot Ford F-250 7.3 Diesel.

I did not use this as intended but it worked fine for my 1971 Monte Carlo Fuel Gauge Signal Wire. I had to close the nest a bit with pliers, but it worked great. The original is very difficult and expensive to get, after soldering it into the factory wiring harness there were no problems. The fuel level sensor reads as it should.

I bought this for a coolant temp sensor on my 1997 7.3. It didn't fit due to the missing slot in the brass inner tube. I called Standard and they confirmed it was defective and needed a slot to install. They didn't offer me a replacement so I made my own cut with a screwdriver. Now it fits well and works just as well. It costs less than 2.00 and was a real standard so not a bad deal but you might have better luck than me and get one that works right away.