Review on 🖼️ Enhance Your Creality Printer with BIGTREETECH Graphic Display Controller for Effortless Control by David Pirlet

So once it works it's really good but you don't need to print a special mount or case for it as the handle is in a different position. I've only been 3D printing for a week. So if you have a bit of common sense and aren't afraid to just try different things, you should be able to get it working with your cr10. I haven't seen anyone here post anything about this printer. So if you have one, here's what I did to make it work. Connect the original cable as is and add the second 5 pin cable with 5 male to female jumpers at the monitor end. And if you connect it to tft and rs323, make sure you connect the opposite pin to rs323 if there is one on the motherboard. So if you are looking down at your motherboard, the leftmost pin plugs into the rightmost pin on the board when looking down. When switching between touchscreen and LED, it still takes about 3 seconds to connect. Writes that a few seconds is not connected, disappears and works fine. So good luck and just play around until it works but don't complete it. And don't give it a bad rating for not doing your research and seeing that it's difficult to install. Too many people leave bad reviews because they were lazy and didn't even read the reviews.