Review on uxcell 1/4 Inch CCD Flush Mount Rear View Camera for Backup Assistance by Pius Aponte

This camera works but the image is too big. After much preparation, I mounted it on the trunk handle of my 2005 Dodge Ram 1500. No, no matter how hard I tried to set the corner, I couldn't see my clutch. When I got the view as close to the hitch as possible, about 2 feet away, all I could see was the ground. I wasn't sure if my settings were correct because backup cameras weren't an option when my truck was built, but there are some aftermarket cameras that led me to believe it should work (e.g. Master Tailgaters Dodge Ram 2002-2008 BLACK tailgate handle with reversing camera). Knowing this, I ordered a few other cameras in different styles. It turned out that most of them work fine and I didn't even have to adjust the angle much. This camera took me a lot more trouble than I had hoped, but thankfully various cameras have been tested successfully and I didn't have to drill any further. holes. I still lost a lot of time, especially since I had to order an RCA extension cable, but in the end my setup works. No thanks to this camera. The camera I chose is: istrong reversing camera night vision IP68 waterproof 175° angle of view no color difference intelligent on/off switch the width and length of the guide lines are adjustable. I'm sure this camera will work for some, but you have to mount it low and point it straight. Still, the image you get isn't as wide as what you see from other cameras. Many Thanks.