Review on 💪 Enhanced Pneumatic Fittings for CHPOWER Filament: A Definitive Upgrade by Aaron Ward

Name: 💪 Enhanced Pneumatic Fittings for CHPOWER Filament: A Definitive Upgrade
Item: 💪 Enhanced Pneumatic Fittings for CHPOWER Filament: A Definitive Upgrade
Rating: 1

August 24, 2022

Not worth the best in 3D printer parts and accessories

This pipe is terrible, firstly the inner diameter is not the center of the whole pipe, after installation there were all sorts of tension problems, it is very soft so just cut the fittings in and put on a problem to remove it. So if you don't like disappointment, don't buy this junk

Pros

High temperature resistant as only the highest quality PTFE is used. Our XS tubes operate at higher temperatures than our TL tubes.

Cons

Crumpled

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖨️ 3D Printer Parts & Accessories

BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes

4.18

13 Review

BIGTREETECH SKR Mini E3 V3.0 Control Board + TFT35 E3 V3.0.1 Graphic Smart Display Panel Board New Upgrade 3D Printer Parts For Ender 3, Ender3 Pro, Ender 3 V2

4.29

13 Review

Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards

4.14

19 Review