Review on 🚁 Happymodel Crux3: 115mm Toothpick FPV Racing Drone with CrazybeeX 5A AIO and CADDX Ant EX1202.5 KV6400 Motors (DSM2/X SPI Receiver) by Jim Cox

Binding information! are too short so you just have to use them as a press fit without securing them in place. Poor mount documentation and took a long time to figure out, thanks HappyModel! Rubber bands are expected to be used, which is very stupid. The Insta360 Go mount is made of TPU and is so poorly made that it won't snap into place (probably depending on the pressure). Most of the screws were not tightened so check them all before flight. .Two-blade propellers do not fully exploit the available power, but only consume 7.2 A full throttle. Switch to triblade supports. The VTX antenna is bare copper wire and is not configured correctly (wrong length). works if you apply a lot of trimmers to balance it. The bind button is not visible to those with poor eyesight. Use Betaflight to set the bind mode on the bind_rx command line. Good. It flies better than any other mic I have. tried it out, really amazing how responsive yet stable it is. Excellent video performance (close range) and will likely improve with an antenna mod.