Review on 🚗 Enhance Your Vehicle's Efficiency with the Directed Electronics Inc 528T 12v Accessory Pulse Timer by Matt Welch

Motorcycle - Perfect little delay timer for my Hayabusa low beam HID. I have actually used this unit with a direct HID relay harness from the battery to the 528T and then to the HID ballast. After reading reviews on Revain and online I drew my wiring on paper and it worked the first time. For non-technical people (because the instructions don't even say what the thing is). it takes about 20 minutes. at your own risk!1. Orange wire = red/positive output2. Solid black = negative output. (See "Note" in step 4 before beginning this step).3. Yellow and Red (twist, tie, solder, glue together) are positive inputs > this means your power (Red or +) is coming to the 528T from the battery or AC adapter.4. The "solid black" and "black with white stripe" part of the cable is input = negative from the battery or power supply. (Trick: Connect that solid black wire to the "Y" wire. Twist one side of the "Y" connector you just made to the black wire with a white stripe.) The other half of the solid black "Y" - Wire goes up. -Step 2. Don't use: You won't use the brown wire (or at least it won't be needed for the delay timer) and leave the blue wire loop alone. After completion: Check all cables to make sure they are in a heat/water tight tube (duct tape works but gets dirty after a few years) and secure. light it up The timer on mine was set to maximum and I figured it wasn't going to work. I moved it counterclockwise for a shorter time. I set a delay of about 20+ seconds. Hope that helps! Enjoy.