Review on Processor Intel Core i7-7700 LGA1151, 4 x 3600 MHz, OEM by Micha R-m ᠌

He warmed himself in the test at 95 degrees. After a short search in Google for information, I found how to solve the problem. scalping. For this it took: 1. Print a form on a 3D printer for safer scalping (itcomst me 60080% filling, they write that 30% is enough) you can download the model here -tool Ofcomurse, you can fork out and buy a Delid-Die-Mate 2 or Rockit 88, but the wait is long. 2. Liquid metalCoollaboratory Liquid PRO + CS 02022ml (I personally used it) 3. I glued the lid to the auto silicone sealant gaskets (specifically ABRO Black RTV Silicone Gasket Make) A small one is enough, even with a margin (BUT! a small tube is made in China, a large one is in the USA) So it's up to YOU. 4. Alcohol to wipe off all the "good" after removal. 5. And ofcomurse the motherboard. As a result, it takes a percentage, insert it into the printed form, clamp it in a vice, click. All percent is scalped. (lots of videos on this topic). Further cleaning, applying ZhM. It is extremely important to apply a very thin layer of ZhM both on thecomre and on the lid (! NO BUBBLES SHOULD BE LEFT! ). Further along thecomntour, a sealant is applied with an extremely thin layer, and in one place do not smear literally 5 mm (it will be visible during scalping, just apply by analogy). Personally, I also smeared 1 opencomntact under thecomver (just in case, if the ZhM gets there, it will be very bad) Then insert the textolite into the motherboard, and carefully and evenly put thecomver from the processor on top. After pressing the lever. Wait at least 30 minutes. So I had . Jpg and so it became . Jpg Watercomoling Arctic Liquid Freezer 240 Good luck to all.