Review on 🏠 Enhanced Home Security with IDAODAN Dummy Security Camera - Realistic Simulated LEDs, Outdoor/Indoor Use (4 Pack)! by Adam Browning

I received 4 "cameras" individually wrapped and boxed. Fastening screws are included in the scope of delivery for installation in hollow walls. If you mount the camera on wood, discard the screws. I drilled 3 different sized pilot holes, progressively larger, the third hole was almost the same size as the screw, the screws don't bite. I used my own screws and proceeded. No one has mentioned some of the best features of these cameras. I wanted a screw for the base to be the top screw, there are 3 screws on the unit that allow you to position the unit in almost any position, I removed the screw that attaches the camera to the base, I could fix it wanted to install anyway. There is a screw that allows you to point the front of the camera up and down. The third screw allows you to adjust the rotation. You don't need to remove the screws to raise and lower or rotate, just loosen them. The whole unit is well thought out and implemented. The signs that come with each unit are adequate, but large enough that they need to be bent to fit the box. No problem. I placed the signs in the binder, made sure they were flat and laid the binder on a flat surface, then weighed the signs, half an hour later they were ready for posting. The only downside of these fake devices if I hacked there would be no video to show the authorities. Hopefully that's enough to prevent a hack. The piece of spaghetti that serves as the wire for me was only attached at one end, it's obvious where the other end goes, so I smeared some glue on each one. then stick it in the hole. Decrease the chances of the wind blowing it out of the hole.