Review on 🔌 Aokia Power Cordless Drill Kit by Dmitriy Kingsley

This is a lightweight driver/drill that I don't think would hold up to professional, heavy-duty, continuous use. Its ability to dissipate heat and dust from continuous use in a work environment is limited. But suitable for light occasional applications where only a few screws or drilling are required. The chuck does not feel hard when inserting the tool. Clamping is carried out by turning the two circular rings in opposite directions so that the inner ring cannot be gripped with work gloves. I had to take off my gloves to use the tool. However, when the tool was properly secured, I had no trouble using it. It comes with a case, charger (see comments below), tool case and a set of drill bits and tools. When I received the screwdriver/drill set from the carrier, the tools were scattered in the box, indicating a lack of delivery and quality control. The operating instructions do not apply to this drive/drill. See photos. Also, some information is wrong. The booklet indicates a charge of 1500 milliamps at a voltage of 21 volts. I have a 1000 milliamp charger. This increases the loading time by 50%. Also, there are no indicator lights on the drive/drill to show the charge level. So there is no way of knowing how long a screwdriver/drill can be used, if at all. There are no instructions for switch 1 2 on the top of the screwdriver/drill. On my other drivers, this mode would switch from constant torque to hammer mode (which this unit doesn't have). It doesn't seem to have any function when in use. The switch is difficult to move. This driver/drill does not satisfy me.