I have an Ender 3 V2 with board 4.2.2 with the latest Jyers UI firmware. I used to use the manual grid method to have a fully calibrated bed, but it was a tedious process and I chose the Bl-Touch V3.1. After installation everything was better (no more manual settings). Now I bought the CR Touch because I wanted to compare my current setup with the Bl Touch. The first impression is really good, the product comes in a nice and sturdy packaging. which protects the contents (Important!, Bl touch comes in a thin foam protected plastic bag). The package includes everything you need to set up the hardware. Since I already had the Bl Touch installed, all I had to do was change the probe. The attachment mechanism is simple but works very well (very clean install). It was a bit unclear how to attach the probe to the mounting part, as the screws have to be inserted from the bottom up (the instructions didn't help with this part). I used the previous cable from my Bl touch as it was already installed and connected to the motherboard. But the cable that comes with the CR Touch is much better, it's ready to use right out of the box. With the Bl Touch Kit, I had to solder a JST-XH 5-pin connector to the end because I didn't want any problems with the included pins. I've done some bed-level testing with both sensors and can say that the CR Touch seems to be more accurate and consistent. All in all, if you have an Ender series 3D printer, just get the CR Touch and don't bother with the setup process by soldering wires like I did. noticed that the CR sensor makes vibrating noise when moving the X axis, since the probe is all metal I think it vibrates and makes noise, no need to worry, but the BL sensor was absolutely silent (because everything is made of plastic). .
10Mm X 11Mm Black Plastic Open Type Cable Wire Carrier Drag Chain Towline R18 For 3D Printer And CNC Machines - 1 Meter Length
7 Review
Befenybay 2020 Upgrade: X-Axis Synchronous Belt Tensioner For Creality Ender-3/Ender3 Pro/Ender3 V2/CR-10/CR-10 V2/CR-10 V3/CR-20 Pro –Straighten And Stretch For Enhanced Performance
50 Review
BIGTREETECH SKR Mini E3 V3.0 Control Board + TFT35 E3 V3.0.1 Graphic Smart Display Panel Board New Upgrade 3D Printer Parts For Ender 3, Ender3 Pro, Ender 3 V2
13 Review
Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards
19 Review
UV Curing Standard Photopolymer Printer by IFUN
5 Review
🔵 IFUN 3D Rapid Resin - Low Odor Photopolymer Resin for 405nm LCD 3D Printer - Fast Curing, Standard Rigid Formula - Sky Blue, 500g
5 Review
🖨️ FLASHFORGE Adventurer: Enhanced 3D Printer with Removable Extruders and Monitoring Features
4 Review
Flashforge Adventurer 3D Printer with Detachable Precision Leveling System
6 Review