Review on Thermo Tec 13500 Adhesive Backed Barrier by Jeff Payne

This worked great for my application! It turned out to be a bit thinner than I expected, but I didn't mind too much. I applied it to the underside of the Creality CR-10 print bed. Fits perfectly, no cutting required. If someone else wants to do the same, be careful with the power cords on the print platform. Maybe even cover them with kapton tape before applying this. The aluminized finish can easily short out these kids if you're not careful. In any case, the glue is holding up well so far, even after being exposed to 60 degrees Celsius for more than 16 hours. I will definitely update this review if at any time the adhesive starts to fail.