Review on 📲 RinoGear Clear Film Screen Protector Case-Friendly for Xiaomi Huami Amazfit Bip (6-Pack) - Accessory for Full Coverage Display Protection by Troy Early

Not bad protection, it's some kind of film, not glass. The best I can compare it to is thick plastic wrap. My amaxfit Bip watch bangs all day, and although the film scuffed/scratched a bit in about a month, it didn't block my view of the screen at all. Sometimes small blisters appeared, but they were very easy to push out with your nails. Hell, you can raise half the profile and it lags just fine. However, after about a month I had to replace it as half the protection had peeled off while I slept and was collecting lint/dust from my sheets. At the same time, there are six pieces in the package, so there were no problems with the exchange. Now for the installation: follow the instructions as they say, dip in soapy water, place and you're done. But then I had a big problem with the sides not adjoining the bend (see second photo). I tried to hold it but even after 10-20 minutes it reappeared. And I didn't want to keep it up all night. So I found a system where I placed the clock on an object (an inverted bowl) in another bowl (see third photo). I then filled a plastic bag with water and put it over my watch (see fourth photo). This allowed the weight of the water to flex around the curves of the dial and hold the protective film (see last two photos). I left it overnight and in the morning it was like a glove. A bit blurry for a few days but it's cleared up so well I don't notice until I think about it. Amazfit Bip is waterproof, so you don't have to worry about bag leakage. In theory, it should be possible to fit the watch right into the bowl, but despite claiming to be water resistant, I didn't like the idea of a leak keeping my watch soaked in water all night, so I added an upside-down one just in case Plate.