Review on Enhanced OUYANG Twotrees SP-5 3D Printer with Advanced Features by Draven Invert

I knew it was a smaller spool when I ordered but didn't count and didn't know how much smaller. While not the most economical roll size, there may be times when you need or need a small roll. Other than that, I do a lot of 3D printing and use a lot of filament. I find if you set the right temperature and your bed is level all filaments will print fine. The two things I want to achieve when buying filament is that it should be vacuum sealed and properly wound on the spool. This filament is vacuum sealed and the wind on the spool, although I've seen better, is fine too. It prints very well and I've had no problems with it sticking and peeling off the bed. For me, the 210 degree jet and 60 degree bed worked great.