Review on Rfiver Universal Swivel TV Stand/Base - Table Top TV Stand for 32-65 inch LCD LED 📺 TVs up to 88lbs - Height Adjustable Center Pedestal Stand Replacement with Tempered Glass Base, Black, Heavy Duty by Kofi Wills

This review is for the 32-65 inch model. I bought two of these TV stands. I have one on a 55" Sony and one on a 65" Samsung. I assembled both coasters fairly easily. Several people have mentioned rubber washers in their reviews, which are used where the back of the TV mount connects to the stand post. These washers are used with two screws. you can use to rotate the stand. The washers are brittle and will tear and push out of the connectors when you first turn the TV back and forth. Once pushed out there is no friction and the TV moves too easily. With these washers I used a 5/16" fiber washer. I'm sure a nylon washer would work just as well. The new washer provided good friction, allowing the TV to be moved easily, but it stayed in place I would not recommend using the washers that came with the stand Most hardware stores sell fiber and nylon washers I paid $0.80 for two washers at Home Depot (model #807918 online #204276418 store #765225 ).I bought these stands to provide adequate clearance for the center channel speaker.If you find yourself in the same situation, be aware that the lowest screw position on the TV mount is when the mount is in its highest position on the stand is 13.5" from the base of the stand to the lowest screw hole on the bracket. The position of the mounting screws depends on the F tv so you need to know their position to calculate the distance you get from this stand. In addition, the stand mounts have a maximum vertical distance of 400mm. My Samsung when mounted on the highest position was just below a gap of 1.5 cm. My Samsung uses a 400mm spacing, so I couldn't raise the TV any higher in the mount. If Samsung had used a 300mm spacing, I could have gained another 4 inches by mounting the TV higher on the bracket. The screw holes on my Samsung are high above the bottom of the TV. On my Sony TV, the screw spacing is about 2-3. " from below. So I had enough free space on my Sony TV. You can also mount the TV mount at three different heights on the stand. Each height varies by 2.4 inches. You can install swivel brackets on the stand ( The 13.5" spacing I mentioned was when both mounts were set to their highest position. Again, the 400" spacing is mm - the maximum horizontal spacing on the mount that attaches to the TV is 2.4" - the distance between each of the three positions available for installing the TV mount on the stand 2.0 inches - the distance between each of the three positions on the stand 13.5 inches - height from the bottom position of the screw on the TV Mount to base when mount is installed in the highest position