Review on Reboot CUT50D Plasma Cutter Machine: 50Amp, High Frequency, 110/220V, Clean Cut, IGBT Air Plasma Cutting Machine for Aluminum Alloy, Mild Steel and Cast Iron by Justin Abrams

Bought this for $191 on Prime Day and I think it was worth it. I'm not sure I would pay the usual $240 for an apparently incomplete machine. I have not contacted the seller regarding this, so I cannot confirm a service/support score. I too must clarify my post. I'm not complaining, I'm just pointing out the problems I noticed when I bought it. If you buy cheap, I know I expect cheap. Here are the problems I'm having: The trigger won't attach to the flashlight. It just hangs there and falls down if you don't hold onto it. I had to tape mine to the flashlight. I have the impression that there is a lack of detail. The air regulator/moisture separator is leaking heavily. It technically works and they even advertise it as a newer updated regulator, but you'll probably have to buy a new one. The air hose is small so you'll need to find a way to get a standard 1/4 inch air hose. associated with the car as there was nothing to simplify. The manual seems to cover a few different models, but I don't recall seeing anything about knob settings. However, there are PSI suggestions on the front. I cut about 60 inches from 11ga and some 3/8 inches.