Review on Motorcraft TPMS19 Transmitter by Patrick Cooney

2016 F350 4X4 -- works great! 65psi the only way without that clicker) and it will cost at least 20 minutes of your life if you get it right the first try. I have now found this and am able to reset TPMS locations in about 2 minutes. Here's how it works, step by step (tire holder instructions that worked for me): 1. Make sure all tires are inflated to the vehicle's recommended tire pressure (listed in the owner's manual on the door sticker).2. Turn the ignition key to the OFF position, then press and release the brake pedal.3. Turn the ignition key from OFF to RUN (engine off) 3 times and end with RUN. Do this within 10 seconds.4. Depress and release the brake pedal.5. Turn the ignition key back to the OFF position.6. Turn the ignition key from OFF to RUN (engine off) 3 times and end with RUN. Do this within 10 seconds.7. An audible signal should sound to let you know that the vehicle has entered TPMS8 relearn mode. Place the VT10 antenna on the side of the front wheel on the driver's side in the valve stem location.9. Press and hold the left button of the VT10 trigger for 5-10 seconds. The vehicle horn will beep to indicate the sensor has been learned.10. Once the beep sounds, move to the front wheel on the passenger side and repeat the process. Each bus should not last longer than 30 seconds. 11. After examining the front passenger side tire, continue with the rear passenger side tire and finish with the rear driver side tire.12. Now you can turn off the ignition. If the signal tone does not sound, the sensors have been taught in successfully. If the beep sounds twice, the process must be repeated because a malfunction has occurred. READY! If you change tires and own a Ford with TPMS, buy this now!