Review on 🌈 DIBMS LED Headlight Strip Tube Light 60cm 24 Inch Dual Color White & Amber Yellow Waterproof DRL Neon Lights Turn Signal Bulb Sequential Switchback 2-pack by Michael Langelius

In general I would stay away from it. 1) Adhesive strips - nonsense. The light strip comes off very easily. It also goes under the rubber end cap for some odd reason. When you remove the plastic from the tape, it opens the plugs. 2) Rubber stoppers do not hold well. They fall off easily because they are too big. This is a problem because without the caps, water can get in and damage the LED strip. 3) Light band is very, very fragile. The housing is easily punctured when pressed between the headlight and the body. This was done with a thick rubber car trim tool. The only safe way to install them is to loosen the headlight bracket, lift and insert the light strip, and then reattach the headlight. 4) Blown LEDs within 24 hours! No rain, no car wash, just a nice clear sunny day. As you can see from the photo the lights are not too bright in daylight as they are very thin. At night they look bright. The driver's shoulder strip has a couple of non-working LEDs at the end that actually light up at night. You can clearly see that some of them are not included. I wanted to like it, but with the issues listed here, I wouldn't recommend them to my friends or family. They look like what a young novice driver would put on a car with a club to make it look better, not like a professionally applied product on a good car. I spent a lot of time getting the wiring right for a clean, factory look just to keep the LEDs from dying after 24 hours. Not too happy but don't feel like canceling opening times. Will likely use the wiring and replace later with another, better product if or when it releases.