Review on 🚰 SHURFLO 4008-101-E65 3.0 Water Pump: Revolutionizing Performance for Improved Searchability. by Daniel Mandal

I'm a regular nerd who "gets nimble" on the weekends. It was a very easy job replacing my old cheap Shurflo that was vibrating out of my cheap RV tubes. The equipment was the same as my old model (details below). I also used the filter from the old model and got a chance to clean the plastic splinters (from the factory fresh water tank installation?). The only "weird" thing I had to do was relocate the rubber feet because the screws wouldn't get stuck or fall out. So, you know, if that was the worst thing I had to do, it was easy. This new one runs much smoother. The pump is quieter, and therefore most of the piping is quieter. The long pipe that runs from the kitchen (where the pump is installed) still vibrates about 8 feet into the bathroom. You'll probably have to climb up there and tie them to something to reduce the vibration even further. but it was easy to spend money to halve my awkward mood, or better. The previous model was a 2088-422-144 dual-diaphragm unit that shook the floor and walls quite a bit. Attached photo left: new 4008-101-E65; on the right is the old one.