Review on DEWENWILS Outdoor Wireless Controller Compatible by Jesse Hughes

I don't see how anyone can give less than 5 stars unless durability fails. I have a 2 story brick house, it is on the outside wall of the house. I received 3 sticks from the router. I have an external repeater so the cameras and when they go out onto the pool deck get 5 poles that I connected them to. If you don't know how to read schematics, now I'll help you. I should have learned it a long time ago too. Open the manual, find the water tank you will most likely use for 220. The two jumpers that come with the kit install first of all (makes life easier) the two left screws (all memory) L1 and L2 they are connected here (nothing else so tighten) black should power this L1 and white neutral in be L2). Look at the diagram, one goes to the rightmost screw, the other goes somewhere in the middle. Comb and place them in their places. Now you only have 4 screws plus a ground at the bottom just in case. First, I connect the devices so that there is no power, although you should have turned off the switch. Copper wire depending on equipment. Then a black wire and a white one that go to the screws where the jumpers are attached to prevent them from being tightened. Then the power wires from the switch box (black and white) go next to the jumpers and the ground from the box goes to a screw on the inside of the box where the other ground went, they go together. Then you are done. I'm out of memory so I didn't say where white and black go via which hardware jumpers. Take a pen and mark where you are going on the chart before you begin. makes it easier Once you know where everything goes, installation is done in 30 minutes. Mine was a 10, just replaced the manual timer with this and used the old mounting holes and the line was flexible and attached directly. Jumpers to activate the timer, why are they there. CONGRATULATIONS. I put the instructions in the box in case I need them again. Since they're waterproof, they should be fine. I programmed the Wi-Fi with a Samsung Note 10. You go to your Wi-Fi, look for the signal that the box puts out and connect to it via WIFI. Your phone may report that there is no wifi on the line and this is normal. At this point, you should already have the app installed on your phone. Go to the app and follow the instructions. You will be prompted to select Wi-Fi, then enter your Wi-Fi password, click Next or Continue and you SHOULD be good to go. Press the power button in the app, it should turn on the hardware. OPTIONAL IF PURCHASED FOR A TIMER. Go to the timer, set the start and stop times and select the days you want it to run. If you are in the hour at the time of setting the run time. After programming the timer via the app, turn the device back on. The timer turns it off at the right time. This should be the last thing you need to play with the app unless you change the time or want to toggle it on and off manually. Hope this helps, it's hard to write an explanation from memory. But I tried, Happy Holidays and many, many New Year's Eves ahead.