Review on 📺 Kanto PDX700 Full Motion TV Wall Mount: Supports 42-inch to 100-inch TVs, 150 lbs Capacity, 90° Swivel, +15°/-3° Tilt, in Black by Shaylon Bateson

Absolutely EXCELLENT product. Design, finish, packaging, website and customer support are top notch. It's nice that things are working as expected. Everything you need to install the mount is included in a very well organized kanto box Wall mount bracket to mount a large flat screen I'm sure you need look no further. The only useful tip I'd like to add for installation is that TV installation height is often critical due to the target's physical limitations, location and/or personality. For the ultimate owner's desire, it is helpful to have a reference point to determine the EXACT VERTICAL POSITION of the stencil on the wall. This can be done by piercing the template with an awl at the location of the top stud (1 of 3) that is welded to the TV mount. I was able to achieve this goal using the following process: 1. After installing the bracket pieces that attach to the TV, measure from the bottom edge of the TV to the top stud.2. Use a pencil and tape measure to mark this point on the wall (now you know where the top and bottom of the TV are from this reference point)3. Then place the template on the tabletop and place the compressed hinge portion of the wall mount onto the template, obviously lining up the holes on the mount with the template. Then use the pen to mark a point on the template and align the U-shaped grip point of the rotating bracket.4. Remove the template, punch a hole at the mark.5. Assuming you've already determined where the wall studs are, position the template horizontally where you want the bracket to end and use a push pin to temporarily secure the template in the desired vertical position (based on the dimensions given above from the pin hole to). bottom and top of TV)6. Continue to follow Kanto's instructions to complete the installation. This may sound complicated, but it makes sense and is fairly easy to do once you have the jig and template in your physical possession. I've also included a few photos of the template with pin hole markings. The project should not take longer than 1 hour. Much luck.