Review on 🏍️ Etopars Black Universal Motorcycle Motorbike Headlight Mounting Bracket: Secure Lamp Housing with 38mm-51mm Mounting Clamps by Mark Deuschle

This article does not correspond to the advertised parts. I have an inverted fork on my bike with a thick section at the top near the headlight where I wanted to use the brackets. They're about 47mm long so I figured a range of 38-51mm would be suitable, but the screw that came with it was too short so I had to buy longer screws to fit. The mounts also required quite a bit of flexing and maneuvering to fit my forks. I'm also not sure how long they will last as I had to make modifications. Fingers crossed they are fine. It took quite a bit of extra effort to install them on my bike. But the seller and potential buyer should be aware that the brackets run small. I bought the advertised 38-51mm but the screws were too short and the brackets had to be bent. With this in mind, the seller must either adjust the advertisement for this product or replace the screws with longer ones that fit the advertised product. Based on another review which seems to be trending as this customer bought the 31-39mm version for the 33mm forks and they didn't fit this bike. If you are considering buying them. If your forks are in the 31-39mm range, buy the 38-51mm range. If like me you have upside down forks, look elsewhere or get ready to do some modifications of your own and risk damaging the mounts or worse your bike. On a positive note they were delivered quickly and weren't overly expensive so I didn't spend a lot of money on them and felt comfortable making adjustments myself. Good thing they don't cost more than $9.