🏍️ Etopars Black Universal Motorcycle Motorbike Headlight Mounting Bracket: Secure Lamp Housing with 38mm-51mm Mounting Clamps Review

I haven't had any bad reviews, this is my second set and I'm quite happy with both. They require a bit of adjustment but will fit a variety of fork sizes. No hardware or quality issues, it's just cheap and works

Does not match fork size, if you do not replace the bolts with longer ones, the bolts will tighten the bracket, recommend ordering a larger size than necessary, or get longer bolts , the product looks good , is held up so far by the dual sport.

I used it to fit a 6" headlight and then replaced it with a 7.75" headlight. two hex head bolts slipped and will not tighten or loosen after being moved once, as long as they improve their quality, this is a 5-star product.

I bought the 31-39mm version thinking it would fit a 33mm fork but it doesn't. The product is not the same as in the photo. The sales picture shows 3 spruce adjustment holes, but I only have 2 (as shown in the picture). There is no round shape when appropriate, much like an oval. The screw hardly reaches the other side either. Useless to me.

Bought these to fit my Benelli TNT 137. My calipers measured 47mm fork tubes. However, NO WAY will they continue with the supplied screw. I bought a 10mm longer screw and it worked. Once you start tightening the bolt, the clamps will fall around the pipes. At this point, the supplied screws are long enough. Worked for my purpose and for $9, wth.

My forks are 36mm, these clamps have two slots and this photo is in the largest slot. I've tried bending, but due to the way they're designed, you'll most likely pull the clamps right out of the groove they go into. I would NOT recommend modifying/bending and using other screws even if you are good at such things. Don't waste your time, buy another set with better reviews. The paint also chipped quite easily when flexed.

This article does not correspond to the advertised parts. I have an inverted fork on my bike with a thick section at the top near the headlight where I wanted to use the brackets. They're about 47mm long so I figured a range of 38-51mm would be suitable, but the screw that came with it was too short so I had to buy longer screws to fit. The mounts also required quite a bit of flexing and maneuvering to fit my forks. I'm also not sure how long they will last as I had to make modifications…