This resin tank looked better straight out of the box than the plastic tank that came with my Anycubic Photon Mono. The FEP film turned out to be dense, although there were scratches and dents, as well as a cloudy substance that I tried to clean with isopropyl alcohol. It remained a little cloudy and appeared a bit greasy from the bottom out, but I went ahead and did a few test prints. The first complete failure, fully adhered to the FEP sheet. When I tried to take the bath out of the printer it stuck to the glass of the digitizer screen and wouldn't come off - on the next try it happened again so I think there's a tiny leak somewhere and the resin is kicking out on one side something out of. If the best FEP film was correctly installed on it, that could be great, but since it only came pre-installed, it's impossible to tell if it's a design issue or just a badly installed FEP film. I noticed that the FEP is held on with far fewer screws than my original barrel, which I found odd. It was recommended as an 'must buy' as an upgrade from the plastic maker case so I wasn't thrilled due to the high expectations.
BIGTREETECH SKR Mini E3 V3.0 Control Board + TFT35 E3 V3.0.1 Graphic Smart Display Panel Board New Upgrade 3D Printer Parts For Ender 3, Ender3 Pro, Ender 3 V2
13 Review
Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards
19 Review
BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes
13 Review
10Mm X 11Mm Black Plastic Open Type Cable Wire Carrier Drag Chain Towline R18 For 3D Printer And CNC Machines - 1 Meter Length
7 Review
π¨οΈ IFUN 3D Printing Liquid Resin: High-Quality Innovative Solution
5 Review
UV Curing Standard Photopolymer Printer by IFUN
5 Review
π¨οΈ ANYCUBIC Assembled Innovation Off Line Printing: Streamline Your Printing Process with Cutting-Edge Technology
5 Review
π¨οΈ FLASHFORGE Adventurer: Enhanced 3D Printer with Removable Extruders and Monitoring Features
4 Review