Review on SwitchDoc Labs Thunder Board Connectors by Justin Miller
incomprehensible document on switchlab site.
This board comes WITHOUT i2c pull-up resistors. I think the address settings are wrong. preset to 0x01. Although the doc says it should be 0x03 BUT you can't change it to 0x3. The address lines are connected directly to the board.
- Electronics
- No paint required
New products
Comments (0)
Top products in π₯οΈ. Single Board Computers
π Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
55" TV LG OLED55C2RLA 2022 HDR, OLED, dark titanium
38 Review
Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review
Another interesting products
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review