
I used these on a Dewalt compressor to replace the single output and install a manifold around the side. I attached two of these with 3/8 (1/2 OD) standard Pex-B. So far it's flawless. Just be sure to cut your Pex FLAT. As with any pipe if the edge isn't flat you're going to compromise the seal with this type of fitting. These work great! When I pipe the whole garage I'll buy more of these.

High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review

Vacuum cleaner Dreame V9 Global, white
145 Review

1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review

12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review