Review on 🚦 Enhanced United Pacific Brake Attention Flasher Module for LED Brake Lights: Rapid Flash Followed by Steady On by Brent Webb

Installed two weeks ago and so far works as intended. The easiest way to adjust the settings is to use a spare 12V LED light (rear light, side light, etc.) and a battery or charger. word of security. should only be used for a third high mounted brake light and NOT for a vehicle brake light for safety reasons. If the turn signal fails, you will be left without brake lights and risk a rear-end collision. Must be installed with a separate built-in 2A fuse. If the flash burns out, the car's brake lights will not turn off. This should be stated in the turn signal installation instructions. My only complaint is that the wiring color coding is mixed up. The negative (-) wire is white for some reason. should be black (-), red +12V from brake circuit and white turn signal output to light up.