Review on 🔥 Ximimark 20Pcs A4 Sheet Heat Toner Transfer Paper for PCB Electronic Prototyping DIY Projects by Alicia Lopez

I just got a whole sheet of this out of my dad's Brother laser printer. Yes. It could be very bad. I archived it like any other magazine paper and started printing. I noticed that the media never came out of the printer even though it was gone. I checked the normal congestion areas and couldn't figure out where it ended up. This is where it gets fun. So I turn it back on and let the cleaning cycle run and the room starts smelling burnt. I immediately unplugged the thing and eventually found the ENTIRE sheet wrapped around the heated drum. I'm trembling at this point because I just messed up my dad's laser printer in my home office. I start scratching the edge of the paper with a small screwdriver (even my finger didn't fit into the mechanisms). AND I HAVE THE EDGE! YUP! Then I spend the next hour slowly removing sticky paper from my dad's $1,000 printer. Fingers crossed I'll do a test print. And also. Everything is fine with the printer. Picture quality is back to normal baby! YUP! TOUCH! Ooooo! But seriously. Do not take any risks. Apparently this paper does not work in some printers. Let me just say my home PCB craze is done. I will never take that risk again. I'm happy to pay shipping and the full cost of each JLC PCB because it will never result in the disaster I just avoided. OK, I'll drink.