Review on 🔧 Effortless Assembly: Blue Transparent SB Components Raspberry Pi Camera Case/Enclosure in 30 Seconds by Dwayne Quarles

Housing is well made, but the opening for the camera lens is too small. I have bought 4 of these so far and have had to use a drill to enlarge the camera lens hole. I then used a small file to smooth the edges. It takes about 5 minutes for one body. The kit includes 2 screws and a strip of double-sided tape. I cut the ribbon in half and used it under each clasp. I attached the camera body to the Pi body and put screws in each mounting hole. I tried not to overtighten the screws. I left a gap of about 1/32 inch between the Pi body and the camera body mount.