Review on 🔥 10g EasyCargo Thermal Conductive Glue Kit - High Performance Silicone Plaster Adhesive for GPU Heatsink, VRM, VRAM, LED, IC Chips, MOSFET, BJT Transistor, 3D Printer, PCB by Luis Tuazon

I opened the tube, poked a hole in the top to get some glue, then it started spitting and hissing. Luckily it didn't do any damage. I closed my eyes and mouth and then threw it in the trash. It gets hot where I live but the tube has been inside at 80f for 6 hours. word of warning. It could get in my eyes or on my glasses. Can ruin clothes, furniture, carpet, etc. Dirty hands. Dries for several hours. Even then, I was able to easily pull out the glued parts. Which is good considering it crumbled all over my hands and tools when I opened it. Adding memory heatsinks is very easy to remove. I waited about 4 hours before removing the small heatsinks, they were too brittle due to the combination of thermal pad and glue, later I will use the glue alone. Maybe it will get stronger over time? After 12 hours I can scrape it off with my fingernail, I scraped off a pea sized piece of metal that was glued on last night in about 10 seconds. fails when first opened. Dries for hours. I will update if there are problems. While putting 4 stars I will check thermal conductivity later, if not updated then everything is fine.