Review on Wi-Fi router ASUS RT-AC66U, black by Anastazja Andrzejews ᠌

I am attempting to talk him into working for a third consecutive day. Linked to the Beeline system. In addition to a tablet and five other gadgets, I have three computers. I needed a new dir-320 so I purchased it. Dlink plowed for almost two years, but when the tariffs changed, it started slowing down. I decided to go with it after reading the reviews, and after getting it up and running, I updated the firmware to version 3.0.0.4.270. I was able to connect to the Internet without any issues, although at first I didn't fiddle with too much with the settings, and while I was testing the wafer, I didn't give out more than 3 Mbit of download speed at a time. It was necessary for me to switch to the professional mode and pick random incomprehensible parameters; it is unclear what they are measured in. I was able to achieve a general speed of 15 Mbps in both directions. On the second day, it did not permit me to connect to the web muzzle. The typical amount of time it took to open a page on the web muzzle was approximately three minutes. However, by the evening, it started opening normally again. You shouldn't assume that something is configured incorrectly in the system because there were no such problems on dlink and if you cling to the mobile whistle, everything opens normally. However, some of the websites won't open, and this accounts for about 70 percent of the total. You shouldn't think that something is configured incorrectly in the system because there were no such problems. I also observed that the ping is increasing to around 1500 milliseconds! As a consequence of this, there are instances when he mulls things over for an extremely extended period of time before reading the book. I purchased an HP LJ 1022 printer, and after setting it up for three hours, it was still able to print. However, after sending something to print and actually printing it, the process can take up to ten minutes, and this is just for printing plain text! All of this takes place not just on the wafer but also when it is attached to a wire! I want to emphasize once more that dlink was completely free of the aforementioned issues. Instantly printed, yet it took years for the pages to be opened! Although the torrent takes a very lengthy time to start up, once it begins downloading, it provides practically the maximum speed that is allowed by the tariff. The hardware is solid, but the operating system is a nightmare! I will experiment with several types of firmware! I don't recommend it for first-timers, and unfortunately I can't take it back because they bought it in another town. I would have purchased keenetic mega if I had been aware of it! It's not a problem because a friend already has one. After installing the firmware from Merlin 3.0.0.4.270.25, the gigabit network and the n wafer both work without any issues; however, there are issues with the g wafer; the speed is not more than 1 Mbps, and while the speed for the 100 Mbps LAN is more than 3 Mbps, the printer could not be made to work! I have a strong urge to spit in the faces of the people who were responsible for creating this miracle.