Review on 🔑 Dodge Keyless Entry Remote Fob for 2003 Ram Pickup: Easy DIY Programming (Requires 1 Working Remote) by Jason Yancy

Works great! On the advice of a recent reviewer, I followed the TC reviewer's directions and it worked like a charm. I'll post the instructions here as the TC review is older so you don't have to scroll to find it.1. Put the key in the ignition switch. Turn the ignition to the RUN position (as far as it will go without starting the engine). Wait for the ignition noise to stop.2. With a working remote control, press and hold the UNLOCK button on the remote control for 4-10 seconds.3. Within the specified 4-10 seconds, press and hold the UNLOCK button and then press the PANIC button (on the programmed remote) for 1 second and release both buttons. A beep will sound to indicate you have entered remote programming mode (wait 3 seconds for the beep to sound).4. Within 30 seconds of the beep, press and release the LOCK and UNLOCK buttons on the new remote simultaneously. Then press and release the UNLOCK button on the same remote only. A beep will indicate the remote has been programmed. Simultaneously press and release the LOCK and UNLOCK buttons, then press the UNLOCK button on any new remote you wish to program at this time. The locks toggle after programming each additional remote control.6. Turn off the ignition and remove the key.7. test charts. There was a 10 second delay before my old working remote and the new remote started working.