This is a durable plate that is easy to use. It can be powered by a 3.3V or 5V Arduino and probably most other controllers. (The 3.3V setting is different from the 5V setting). I used this board with a vape cartridge and high capacity batteries to create a steampunk hat that releases "steam". Easy setup (with Arduino UNO): Connect VCC to a 5V power supply. Connect GND to ground of the controller. Connect IN1-4 to the controller's DIO pins. Leave the JD-VCC jumper on VCC. Connect your common wire to the center pin of the relay and your power line to the left pin for normally open (off) and the right pin for normally closed (on). Program the controller to record digitally (contact, LOW) when you want the relays to switch. Pros: Simple design. Relays 10A are suitable for most requirements. Compactness. Disadvantages: none.
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
55" TV LG OLED55C2RLA 2022 HDR, OLED, dark titanium
38 Review
🎁 Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE
11 Review
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review