Review on Carrs 221502 Gutter Less Mount Kit by Brandon Peters

Hi all, Carr mount without a slide works and works well. It took me about 5 minutes per side to install them on my '95 Dodge 2500 4x4. The brackets come with all the screws you need, but you're on your own as far as instructions go. I didn't have any instructions in the box at all. It's really easy although the bracket already has 4 pre-drilled holes so just place it on the edge of the body door frame, mark the holes and then drill holes for the screws. I used a tape measure and went from the cockpit to the back of the bracket to make sure they were in the same place on both sides. Then measure from top to bottom and you're good. My big complaint with them is that the non-slide mount is 1/4-1/2" too long. The ends of the lightbar don't fit perfectly, they slide back and forth until you tighten the other lightbar mounts that are just outside the This combo is very helpful but if like me you are a bit obsessive and picky about things in your car then you will probably have trouble with that too.I could have done the same and saved money but I wanted to something perfect so i ordered this and it doesn't.to me this isn't a breach of terms and conditions, i won't be returning them for such a small thing.i have mounted a light bar of 4 kc daylights on these brackets and they are holding up Keep in mind that you will need to trim this pole to fit, some other reviews I've read have complained about this.The standard pole is 56" long & 1/2" long nd you cut them off on each side to keep the center. For example, if the pole is 3 inches longer, cut 1.5 inches from each side. It's fairly easy to do, I used a rotary sander, but if you don't have the tools this can pose a problem for the average Joe.