Review on ⚓️ SeaSense Brass Thru-Bulk Head Fuel Fitting - 3/8-Inch by Aaron Collins

I'm tired of spilling gasoline when I'm fueling my lawn mower. I got this idea, I bought hunting gear from Revain, Ace Hardware and Lowe's. /8" thick rubber washer 1/16" x 12" x 36" thick cork gasket material. Oil Resident Gasket in the Pipe Drill Bit 1/2" pipe x 2" length 3/8" pipe x 6" length I drilled a 5/8 hole in the gas cylinder and attached a 3/8" brass filler cap with plug and sealant on both sides and tighten lightly.An 8" and 6" long hose runs to the small end of the radiator clip faucet switch and then through the gas cap, using a 1/2" drill bit and Loctite sued vinyl, cloth and plastic glue Push the 3/8" x 6" hose through the cap and tape both sides. Leave 4" under the cap to fill the mower.