Review on 2020 Upgraded Xislet Offroad Roll Bar Fire Extinguisher Holder Compatible With Polaris UTV RZR Ranger Can-Am Maverick X3 Commander - Quick Release Mount by Jason Mulah

A lot of reviewers said they could not figure out how to install it. I found the simple instructions they sent but they are pretty broken English. I think I figured them out and will try to translate.1 - Remove backing sheet2 - Attach holder to tube using the short strap. Wrap the short strap through the buckle then fold it back on itself and secure the 'loop' side of the small strap to the 'hook' side of the long strap (this is the most confusing part as I would expect to connect the small strap to itself).3 - Wrap the long strap around the fire extinguisher, through the buckle, and back on itself attaching the velrco (hook and loop)4 - Tighten all strapsAfter looking at it for several minutes and trying various things that did not work, I did find an alternate method that worked for me. Here is what I did that I found worked better.First, remove the self adhesive Velcro and set it aside, I did not use it. Second, undo all of the straps so they all hang loose. Insert the fire extinguisher and run the long strap through the first buckle (but do not wrap back on itself). Do this for all three. Now, put the unit against the bar (bar between buckles) and continue the long strap around the bar and through the second buckle. Now wrap the long strap back on itself and pull tight to snug both the extinguisher and the bar. Now, fold the small strap toward the long strap and secure the long strap over/to the small strap.