2020 Upgraded Xislet Offroad Roll Bar Fire Extinguisher Holder Compatible With Polaris UTV RZR Ranger Can-Am Maverick X3 Commander - Quick Release Mount Review

The straps to hold the fire extinguisher do not fit the mid to small units. They barely attach and have about 8” excess straps. The straps to hold on to the bars fit small bars. They fit my side by side great but not my tractor bar so just know what you will mount it toOtherwise the straps and construction seems fine.

Installed on my RZR side by side in a few minutes. A few notes: You can get the mounting straps pretty tight but not 100%. They can slide on the bar if you don't have it stopping against something or something grippy under them. The straps that hold the bottle are long to accommodate multiple sizes. I have a 2.5lb bottle in mine. You can cut the excess and melt the ends after install or you can fold the excess over and zip tie it like I did just incase you want to go bigger later.

A lot of reviewers said they could not figure out how to install it. I found the simple instructions they sent but they are pretty broken English. I think I figured them out and will try to translate.1 - Remove backing sheet2 - Attach holder to tube using the short strap. Wrap the short strap through the buckle then fold it back on itself and secure the 'loop' side of the small strap to the 'hook' side of the long strap (this is the most confusing part as I would expect to connect the small…

This is a piece of crap. No one can figure how to install and it has no directions with it. Wasted my money. It makes no sense. Do not waste your money!

Poorly designed. Luckily my wife likes to sew and I had some extra Velcro lying around. After sewing extra Velcro on the three straps to hold down the extra 6 or 7 inches dangling in the air I think it will work fine.

We sent this back. It came with no instructions and we couldn't figure out how to install it LOL.We tried following others instructions that purchased this but still couldn't figure it out. Looked like it would be a great product, just too dang hard to install

These do not hold the extinguisher tight enough in my opinion! They slide down the rollbar, too simple of a design! I will be send the 2 I purchased back.

it is a simple product but this design does not work. the velcros do not match to hold the extinguisher. returned it right away. Not recommended.

very dissatisfied. The stitching that holds the unit together ripped out when tightened around the bar on the roll cage. I would like a replacement but have not found there website.