Review on 💧 Moisture Compression of Antinsky Printer Filament by Daniel Shivashankar

Name: 💧 Moisture Compression of Antinsky Printer Filament
Item: 💧 Moisture Compression of Antinsky Printer Filament
Rating: 5

August 24, 2022

Easy to use and hope they last a long time

I have always used a plastic bag and large zippered mag pouch to store the spool of line. But I still have to dry them every now and then. They are quite easy to use and can keep the floss dry if no leakage occurs. I did notice that one of the bags was leaking, but I'm not sure if it was because I didn't close the lid properly or if the hole was leaking. So I decided to seal the hole with tape after vacuuming. After that I didn't see any more leaks. If you have open threads that are not used for a long time, we strongly recommend them.

Pros

Industrial & Scientific

Cons

Not as thick as other picks

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖨️ 3D Printer Parts & Accessories

Befenybay 2020 Upgrade: X-Axis Synchronous Belt Tensioner For Creality Ender-3/Ender3 Pro/Ender3 V2/CR-10/CR-10 V2/CR-10 V3/CR-20 Pro –Straighten And Stretch For Enhanced Performance

4.18

50 Review

Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards

4.14

19 Review

BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes

4.18

13 Review

BIGTREETECH SKR 3 EZ Control Board 32Bit New Upgrade Silent Board Support EZ2209/ EZ5160/ EZ2130 Stepper Driver Compatible TFT Series Touch Screen, DIY For Most FDM 3D Printer (With 5PCS EZ2209)