💧 Moisture Compression of Antinsky Printer Filament Review

I live in the south and it's humid. These bags work perfectly. They hold a 1kg roll and I easily fit two 500lb rolls in one bag. I've opened and sealed them a dozen times and had no problems. Just remember to slide the roller into the corner of the bag opposite the valve and then place the pump on the valve on a flat surface and you're done!

This is the second set of filament packs I've tried. They are not only more economical, but also more powerful than others. The included hand pump works great and I was able to fully seal all my filaments with the included moisture indicators. It's a little inconvenient to get a good seal while pumping out all the air, but it works and works very well. I will buy more if needed. Thank you!

I have always used a plastic bag and large zippered mag pouch to store the spool of line. But I still have to dry them every now and then. They are quite easy to use and can keep the floss dry if no leakage occurs. I did notice that one of the bags was leaking, but I'm not sure if it was because I didn't close the lid properly or if the hole was leaking. So I decided to seal the hole with tape after vacuuming. After that I didn't see any more leaks. If you have open threads that are not used…