Review on 🚀 Ultimate Efficiency Unleashed: Creality Station 10 1Inch Dual Band Platform by Dee Parson

I bought 2 of these. I'm very happy with how big they are. I wish the treat platter was a little bigger, but that in no way detracts from how good they are. I have a QIDI S-box resin printer with a large build volume for reference. The curing platform is magnetically attracted to the base, holding it securely in place. That's cool. It spins quite jerkily at first, then levels off after about 5 seconds. Supporting something may cause it to fall first. I wish it could spin smoother at lower speed and pick up the right RPMs. Their volume is large enough to cure large prints. The e-liquid tank has a full-depth removable basket and a lid that snaps on and is "waterproof". This is great for preventing spills when moving as it's quite heavy when filled. It's quite large and takes about 2.5 gallons of IPA to fill it up. But I can hang the desktop handle on the edges of the container when the entire print volume and desktop are fully submerged in water. This allows me to wash the parts and the build plate at the same time, which is great. The only remark are the timers. I want to set a cure timer in 20 second intervals for the first 2 minutes. Other higher timer settings are fine. With my 3DMaterials SuperFast Gray resin, the post-cure time is only 20-30 seconds. So I have to set the curing time to at least 2 minutes and manually stop the process after 20-30 seconds. But it doesn't matter.