Review on Hy Pro HyPro 1321 0006 Q Coupler by Eric Weber
Requires thread locking and non-locking
Revain is about $13 overpriced. However, I've been using them as a pro for over 20 years and they perform as well as you can expect from something spinning at 540rpm for many hours. Just remember to use silver sealant on the driveshaft and strip it off from time to time adding WD-40 to thin the driveshaft as heat will thicken it. If you don't, it's not going to be fun removing that thing from the driveshaft when it eventually needs to be replaced. Also remember to lock the threads on the set screw.
- 540 rpm
- weak
New products
Comments (0)
Top products in 🚜 Hydraulic Equipment
Bonvoisin Hydraulic Hand Pump Manual Ram Pump 8500Psi Porta Power Pump For Hydraulic Tools(CP-180)
4 Review
Sim Sensitive System 4 Spray therapeutic Chitosan Hair Repair "R", 50 g, 50 ml, spray
7 Review
🏭 PAE Industrial Machinery RO 132
12 Review
🚢 Bonvoisin Shipbuilding Machinery: Advanced Hydraulic Cylinder Technology
4 Review
Another interesting products
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review