Review on 🔥 SG 55 AG 60 Plasma Cutter Torch: Top-Notch Cutting Performance and Precision by Chris Hernandez

I was given this flashlight to try and salvage a Chinese 3 in 1 that came with a PT-31 plasma cutter. The PT-31 punctures consumables and I couldn't find any gaps to use for non-contact cutting. I replaced the PT-31. I soldered the spade terminals to the cable which allowed me to use the spade terminals on this AG-60 switch. The cutter cuts PERFECTLY through 14 gauge stainless steel. Probably about 1/16" kerf with almost no slag. Now I can get good cheap non-contact consumables! (My torch does NOT have a pilot arc, but the arc ignites normally with a tight gap.)