🔥 SG 55 AG 60 Plasma Cutter Torch: Top-Notch Cutting Performance and Precision Review

I bought this to replace the cheap one that came with my Cutout 50. I would say it's a nicer burner. Consumables are cheap. The only thing I didn't like was that the trigger was very soft. The spring effect of the switch is very weak. It works, but makes another smart, very durable replacement a bit cheap.

I was given this flashlight to try and salvage a Chinese 3 in 1 that came with a PT-31 plasma cutter. The PT-31 punctures consumables and I couldn't find any gaps to use for non-contact cutting. I replaced the PT-31. I soldered the spade terminals to the cable which allowed me to use the spade terminals on this AG-60 switch. The cutter cuts PERFECTLY through 14 gauge stainless steel. Probably about 1/16" kerf with almost no slag. Now I can get good cheap non-contact consumables! (My torch does…

These cut or c312. This is a 3 in 1 wig, rod and plasma cutter in one small device. I bought this replacement torch because the original torch didn't fire properly and didn't even sustain an arc. Even after several hours of testing, mods etc. I didn't get a decent result. waste of time! This replacement lamp is easy to replace. The same fit. I had to solder the two jumper wires and mechanically connect them to the wires in the hose. Works perfectly! And the truth isn't too quick to touch on…