I've had the branded belt for a while now so when ordering a new one I wanted to make sure I have the same belt as before. The belt I bought is stamped 11LV02LX and is a size 34/85. I measured my waist before and my waist is exactly 35 inches. I don't like the tongue of my belt coming off my loop so I knew a 34 inch belt would be perfect for me. When I put it on I can close the 3rd hole (as shown in the photo). This allows enough tongue to go through the loop on the jeans. Just to reiterate what belt I bought, I bought belt 34 (32:waist) which is pictured for my 35 inch waist. If your waist is thinner than 35 inches then this belt will work too (let's say 32-35 inches). waist), but you'll just have a lot more tongue. It fits me perfectly through the 3rd hole in the belt which is snug (the 2nd hole will be looser). I am very happy with my repeat purchase. These belts usually last about 3 years and then I buy a new boot. If your waist is more than 35 inches I would recommend going up to a size 36. If it's 35 to 32 then this belt will fit. Make sure you use a cloth tape measure and not a metal tape when measuring your waist size. The metal tape will be inaccurate. The photo for this listing shows 2 straps BUT you will only receive one strap. This photo only shows both sides of the turning belt. Also, this belt will not break unless you pull STRONGLY on the buckle to turn it to the other colored side. I think a lot of people rip the belt because it's too tight. It doesn't mean pulling too hard. Just gently pull the bucket and rotate it slightly. Definitely key people.