3Pack Wall Mount Bracket For Blink XT Review

These are very cheap mounts so don't expect too much from them. However, it is difficult to get them to stay where you want them to be when you tighten the plastic. They work, but hardly. I'm not sure if they will last more than one season.

If you only use them indoors you can use a turn signal holder but if you use them outdoors I don't recommend at all. The Blink mount is unreliable, and even if the device hadn't dropped on its own, anyone with a long stick could easily knock the device off the mount. So I recommend looking at one that actually screws into the case that comes with it.

Recommend! Increases the distance between the camera and the wall compared to the original mount. If your flash camera is used in a corner, this allows your camera to see both sides of the corner, which is very useful. In terms of angle adjustment, it can rotate 360 degrees and tilt 90 degrees, so there is no blind spot. It's a bit more complicated than the original, but there is an installation guide behind the box which is very helpful. In addition, the price is reasonable.

Don't buy them. The reason I bought them was because they said "360 degree view". They do NOT allow you to rotate the camera 360 degrees. The only way to "flip" is to unscrew and screw the wall mount back on. Complete robbery. More work than it's worth. Very disappointed with this product. You can move the camera up and down, but you cannot adjust the camera to other angles. You have to unscrew the adjustable part to tilt the camera, but this doesn't really allow for full freedom of movement…

Excellent product! I would buy them again! They are very easy to install and the fact that they are battery powered makes the job a lot easier. I only see two downsides. First, since the base mount doesn't offer the full range of motion, it's important to purchase an extension so you can rotate the cameras to any angle. This is noted in many reviews, so I suspect most buyers will heed this and buy extensions. But Blink should have a good threaded camera as part of the kit. Second, since the…

After hours of searching for camera mounts, looking at pictures, reading descriptions and reviews, this was my second attempt at installing a mount for my Blink XT2 camera. The biggest problem with this product is the snap ring, which has to fit into the corresponding recess on the back of the camera and hold it securely. It seems to hold up well on the first try. The second time he feels a little free. At this point I was able to screw the base to the wall and attach the camera to it, this was