Header banner
Revain logoHome Page
6204 2rs sealed bearing: lubricated power transmission products for enhanced performance (20x47x14) logo

6204 2RS Sealed Bearing: Lubricated Power Transmission Products for Enhanced Performance (20X47X14) Review

3

·

Very good

Revainrating 4 out of 5  
Rating 
4.0
🔩 Bearings, 🔩 Power Transmission Products

View on AmazonView on ЯM

Media

(3)
img 1 attached to 6204 2RS Sealed Bearing: Lubricated Power Transmission Products for Enhanced Performance (20X47X14)
img 2 attached to 6204 2RS Sealed Bearing: Lubricated Power Transmission Products for Enhanced Performance (20X47X14)
img 3 attached to 6204 2RS Sealed Bearing: Lubricated Power Transmission Products for Enhanced Performance (20X47X14)

Description of 6204 2RS Sealed Bearing: Lubricated Power Transmission Products for Enhanced Performance (20X47X14)

Dimensions: 20x47x14 mm. Rubber seal on both sides. 100% Chrome Steel for higher resistance and durability. Supports 17,000 rpm. Our high-quality bearing is made to reduce your replacement frequency and maintenance cost.

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

Correct assembly numbers

Bearings are ordered with the same number as old bearings that have been replaced. The problem is that the inner diameter of these new bearings is too large compared to the old ones. The required inside diameter is 0.62 inch or 15.73 mm. I'm not saying the bearing company is at fault at all, it's just that the bearing manufacturer really should investigate the full diameter and width of the original bearing unless the manufacturer of the item that will receive the bearings gives up and asks the

Pros
  • Deep groove ball bearing
Cons
  • Shorter cable than other kits

Revainrating 5 out of 5

Fits the reels on my Cub Cadet riding mower

These fit the reels on my Cab Cadet riding mower as listed on the Revain website. This is the third set of bearings for my mower. The first set lasted 8 years, and the second (different brand) - 2 years. However, it appears that either the bearing seals have failed in the second set or there is poor lubrication/lubrication. So I increase the amount of lubrication all at once every two months (about every 25 hours of operation). I will update my review when I have more information to share.

Pros
  • Drive Train Item
Cons
  • Replacement Parts

Revainrating 3 out of 5

Not to be used as a sealed bearing, bad seals

So these bearings were about $2.75, the local parts store wanted a lot more than this bearing so I figured what the heck I'll try these. Well, upon closer inspection you can definitely tell that they were made at a low price, the seal is not tight and has gaps around it meaning the grease leaks out when it gets hot. So I removed one of the seals when rebuilding a lubricated spindle and figured I'd just lubricate it from time to time rather than the fully sealed bearings which contain their own…

Pros
  • Ball bearing
Cons
  • Expensive