🔥 Enhanced Performance GM Genuine Parts AFS76 Heated Oxygen Sensor Review

What can I say, this is AC Delco. Fits my California Emission 95 Chevy Tahoe 5.7 exactly. Comes with lots of cushions and arrived in perfect condition.

Perfect for my 1995 Chevy G20 5.7. Before ordering, make sure you need exactly 3 wires, not just one. I made that mistake and had to order this one and it had a huge impact on my idle and mileage.

Product fits as an exact replacement for the original that left the factory in 1995; However, this did not solve the grease problem through no fault of the replacement part. Would recommend the supplier and the product at any time.

This is the one for 95 Chevy G20. Runs great and the engine coasts perfectly at 195 degrees Fahrenheit. After installation, suggest unplugging the battery for 30 minutes to allow the computer to reset. Chevy 350, freshly rebuilt, 9.46 compression, 89 octane.

I tend to buy OEM electronic parts where I expect the best fit and quality. This O2 sensor worked as expected. Consider purchasing an O2 sensor thread repair tool to clean/repair the threads before attempting to reinstall a new sensor. You don't want to cross it. Also, use a flashlight to warm up the sensor before attempting to remove it. Use a 7/8 ring wrench, not an O2 sensor wrench. To use the wrench you will need to cut the wire harness off your old sensor. Not difficult. Take your time…