Acrylic double-sided adhesive tape for cars 3M 6009F 8mm x 5m x 0.8mm (mounting tape, double-sided adhesive tape) 3M Made in Germany 00-00000739 Review

In most cases, in everyday life and in the automotive sector, it is not at all necessary to use glue, nails or screws to connect two surfaces together. It is easier, faster and more convenient to do this with the help of 3M acrylic double-sided adhesive tape for cars. Has a fast initial setting Elasticity promotes stretching and renewal of the adhesive tape under load Creates a durable connection Double-sided acrylic adhesive tape for cars 3M, which is a base with glue “bonded” into a tape, is a worthy replacement for conventional mounting means: self-tapping screws, screws, bolts, rivets, liquid nails and welds. The adhesive tape distributes the load along the entire length of the fastened surface and creates an invisible seam due to its high transparency. Elasticity promotes stretching and renewal under load. It can also be used for bonding plastic, chipboard, glass, wood and paper products. Due to its high practicality, it can be applied without additional equipment. The base and adhesive composition of double-sided adhesive tape are resistant to ultraviolet radiation, high or low temperature, solvents and guarantee a strong and reliable fastening; Allows you to glue together materials with different structures. Resistant to shock and vibration effects Copes well with temperature changes and has a huge shear force A modern alternative fastener is double-sided tape, which, in addition to fixing, can provide sealing, compensate for vibration, eliminate the need for drilling, stripping and painting! High degree of transparency Has an easily removed protective layer; Resistant to UV rays, moisture, temperature and solvents Application technology: 1. Clean mounting surfaces from various kinds of contaminants. This includes dirt, dust, tar, oil, silicone grease, polish, etc. 2. Degrease the mounting surface with isopropyl alcohol. When degreasing, use materials that do not leave fibers and threads on the mounting surface as rags. 3. Without touching the adhesive layer of the tape, apply it to the part. Eliminate tensile forces. 4. Remove the protective liner from both sides by 1-3 cm and bend to the side. 5. Place the part on the mounting surface and make sure it is properly positioned. 6. Pull the liner along the entire length of the prepared edges.