🚗 Enhance Your Car Dashboard Mounting Experience with AEBTYKJ 80mm Adhesive Mounting Disk - Perfect for Garmin, Tomtom GPS, and Dash Phone Holder (2-Pack) Review

Front: 80 mm in diameter, suitable for suction cup holders of GPS navigators, driving recorders, and early warning devices, convenient for suction cup holders to be removed at any time. Front: The diameter is 80 mm, which is suitable for GPS navigator, automobile data recorder, suction cup support of alarm instrument and convenient for taking down the suction cup support at any time. Back: It has excellent initial and persistent adhesivity, with good stability, and has good viscidity on plastic, rubber and uneven surface. Product material: The main material is ABS and the back coating is the TPU removable glue. It has excellent permanent adhesion under the high and low temperature. The temperature between -30°C to +90°C does not affect the using effect of this product. Reusable: The cementation surface on the back must keep absolutely clean and dry. Alcohol or acetone can be used to scrub it. The cleaned surface can be pasted after the solvent is completely volatilized on the surface. The effect will be better by using electric gun or electric hair dryer to heat and paste in winter. If you are not satisfied with the installation position, you can remove the disk and install it again. If you are not satisfied with the installation position, you can remove the disk and install it again until you are satisfied. You should avoid the contact between fingers and TPU removable glue on the back during the operation. You should put forth your strength to press after pasting so as to ensure the sufficient contact with the glue surface.