📦 Efficient Storage Solution: AllSpace 450036 08 Storage PegBoard Accs 450036 08 Review

As the previous reviewer said. Simply bend the top tab slightly on each side. Once you've lined it up, you'll need to put some pressure on it to make it line up and go in. Then take a knife or a flathead screwdriver and bend the inserted tab a little more. Waa laa. Did. Works perfectly. What offer.

According to the description it fits a pin board of the same brand. However, Revain's Frequently Bought Together recommends another board from the brand. Well I can say they don't work together. I bought two for less than $6 total so it's not worth sending them back, it's a waste of money and resources. You're better than this Revane - pull yourself together!

These shelves are very high quality but will NOT mate with WALL CONTROL slotted and pinned steel panels. However, we made a small change to them and they work great but are permanently fixed. This was not a problem for my application and they are very durable. For the price I would buy it again but if you want mobile shelving that works with the WALL CONTROL system they won't.

This shelf works great with Wall Control steel panels if you use the Attachments have clips that come with a variety of hardware accessory kits that are available. Brackets are placed under the shelf to prevent it from slipping into the slot and tipping over. I'm using an inverted shelf as the shelf for the vertical dryer, but the assembly process is the same for either orientation.

These shelves are very high quality but will NOT match WALL CONTROL grooved and pinned steel panels. However, we made a small change to them and they work great but are permanently fixed. This was not a problem for my application and they are very durable. For the price I would buy it again but if you want mobile shelving that works with the WALL CONTROL system they won't.

available. Brackets run under the shelf to prevent it from slipping into the slot and tipping over. I'm using an inverted shelf as a shelf for a vertical dryer, but the assembly process is the same for either orientation.

saw a lot of bad reviews. I bought it because it was cheap and had some good reviews. As you can see it matches the Wall Control Peg Boards. To use it, bend the top slightly inwards as shown in the picture. If you don't bend, I don't think it will work normally. As a result, it will be hooked and held firmly as shown in the second picture. They are very cheap, durable and the price is low because brain dead people buy these and don't understand how to put them on. I'm buying a few more so…