🔌 5-Pack Ancable UHF PL-259 Male to Female L Shape Right Angle RF Coaxial Adapters for CB Ham Radio Antenna Review

I bought 2 packs and both are defective. The copper or brass pins in the middle at both ends are pushed in and grounded when I plug in the coax cable. Unacceptable. I'm sure the money I paid is ok. for her.

I don't know why but I've only had problems with these connectors. When I received the package, one of them was already torn in the middle. A month later, two more collapsed in half. I would not recommend them.

Pins and sockets in ANY RF cable connector, right angle or otherwise, must be concentric with the axis of the connector and not 5-7 degrees off dead center like internal parts from these offshore manufacturers. objects were. The customer should not be required to redesign and bend the pins and sockets of the internal connectors just to achieve a certain fit. My advice? Find a higher quality supplier or find products you understand before you sell them. Ridiculous.

As with several other reviewers, the two I received are rubbish. Both center connections are off-centre. I had to use needle nose pliers to bend them in place. The streams are wrong and don't seem to match properly. In addition, the typical "star" tab is missing when establishing a connection. I threw them away and will find a quality replacement. I compared mine to some photos and they have the same issues. Should have read the reviews not the ratings.

Plugs only have two tiny prongs to lock onto the socket. These strips are simple and then the connector simply rotates. One of the adapters fell apart. The male part is only pressed in and cannot break when tightening on the machine. When it fell apart, only two brass rods remained inside, touching at a 90 degree angle. How do you say. You get what you pay for. I added photos. "Ancable 1" shows the 2 pins in the connector being stripped, allowing the connector to rotate once tightened. "Ancable

It's so strange it's almost unbelievable. These connectors are the wrong size. Crazy! They should not be tightened until the housing is fully seated in the SO239 socket. No matter how tight they are tightened with a gas gun, the body will still move vertically within the locking ring! I tested this with multiple SO239 connectors on high quality hardware and also tested SO239 with high quality PL259 connectors to prove that these connectors are clean and just the wrong size! Having some quality…